Yada Backup Camera Specifications download pdf (Page 7)

5. At your taillight, remove the light bulb socket from the reverse light housing.

6. Determine the reverse light power wires for your car, designating the positive and negative

wires. If you are not sure of which are the power wires, then please contact your vehicle

manufacturer or reference a wiring diagram for your vehicle.

7. Connecting the Camera Power Cable:

a. Take the open wire end of this cable, and connect it to the power wires of your car (as

determined in step 4). Using the Snap Lock Splice Connectors, connect the Camera’s

Red wire to reverse light’s Positive wire. Connect the Camera’s Black Wire to reverse

light’s Negative wire.

b. Use pliers to squeeze the metal tabs of the Snap Lock Splice Connectors and ensure a

solid connection, then snap the plastic cover closed.

8. While sitting in the driver’s seat of the car with the key in the accessory position. The monitor

will automatically start when connected to a power source. If when you place the vehicle in

reverse there is no image, go to the section “Settings and Operation” for more information.

9. Put the vehicle in reverse. If you have a clear picture, put the vehicle back in park and turn the

key to the o position. You are now ready for nal steps.

10. Use the provided Zip ties to secure wires neatly within your car.

11. Replace the light socket back into the reverse light housing.

12. Replace any interior panels that may have been removed to access the taillight and close your

trunk or rear hatch.

13. Standing with the license plate in one hand and the Camera in the other hand, slide the Camera

along the top of the license plate in order to determine the placement. Best placement is in the

center of the license plate. If you have a rear hatch handle you may need to remove the Camera

bracket, turn the bracket upside down and reattach to the Camera. You would then mount the

Camera from the bottom of the license plate.

14. Peel o the lining of the double-sided tape already attached to the Camera and press rmly to

the license plate to secure the Camera. Make sure the back of the license plate is clean before

attaching double-sided tape.

15. Press the license plate and the Camera mounting rmly to the car to secure and get full contact

between the license plate and the double-sided tape. Screw the license plate back onto the rear

of your vehicle.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Yada Backup Camera Specifications Page 7